Simplifying Vinyl Installations
Tip #1: Find and mark the center point of your pre-masked vinyl sign. Do this at the top and bottom and both sides. At the job site, mark off the center points of the substrate, line up the marks on your premasked vinyl, tape off and apply.
Tip #2: Always leave one inch space at the top of your premasked vinyl to permit masking tape to be applied. Failure to do this can cause unnecessary bubbles underneath the space where the masking tape was applied.
John Thomson (Sign Ideas)
4415 Greenwood Ave N
Seattle, WA 98103
Phone: 206-297-1955
Fax: 206-297-1976
E-Mail: signideas@hotmail.com
